wear impact vibration resistant epoxy ceramic adhesives

　　The description of BD100 impact vibration abrasion wear resistant ceramic tile bonding epoxy adhesives

performance features of our BD100 wear abrasion vibration impact resistant
epoxy bonding ceramic tile adhesive:
1.Two component,white,room temperature curing,the curing product temperature resistant is 100 degree.
2.The curing speed is moderate,with high bonding strength.
3.With good adhesion to metal-ceramic.
4.Excellent in water resistance,oil resistance and aging resistance.
5.The adhesive has elasticity after curing,with excellent impact resistance.

product usage of our BD100 vibration impact abrasion resistant epoxy ceramic adhesives:
BD100 impact wear abrasion resistant epoxy compound ceramic adhesive is used in the self-adhesion,each-adhesion of metal,ceramic,cement,stone,glass,leather,rubber,fabric,hard plastic,foamed plastic etc. Especially suitable for the bonding of
suffering from impact vibration workpiece.When it is used in the sticking of wear resistant ceramic-metal,it can partial replace
ceramic-rubber composite lining plate,when it is used in sticking various wear resistant ceramic spare parts,it can effectively
avoid ceramic chip falling off caused by knock against,bump during transportation or installation.With very high bonding strength,
used in the self-adhesion and each-adhesion among metal,ceramic and wood.Such as the cracked bonding of machine tool bed,
various tank,large module gear etc.

How to use of our BD100 impact wear vibration resistant epoxy compound ceramic tile adhesive:
1.Surface treatment:Grinding or sand blasting to clean up the dust,oil and rust of sticking surfaces,
finally wash it with cleaning agent and dry it by airing.

2.Adhesive preparation:According to the ratio of A:B=2:1,make the A and B two components uniform mixing,
when the temperature is very low,can respectively put the main agent and curing agent into the temperature of 50 degree
environment to preheat and mix up,then according to a given proportion of weighing,mix and stir uniformly.

3.Using adhesives:put the mixed-up adhesive spread to coat onto the surface of pending-sticky material,then fold it,from the middle to all around,knock it on with a rubber hammer for a time,avoid the air getting into it.

4.Curing:Curing:initial curing will take 4 hours at the room temperature,fully curing will take 24 hours (18~22Mpa),if heat it up to
the temperature of 80 degree,keep this temperature for 2 hours,you can do post curing.In this way,it will get higher comprehensive
performance(can improve 30%)