wear abrasion high temperature resistant ceramic adhesive

　　The description of BD300 high temperature anti wear abrasion resistant
bonding ceramic tile repair compound epoxy adhesive

Performance features of our BD300 abrasion wear high temperature resistant ceramic repair compound epoxy adhesives:
1.Two component,gray daub shape,the adhesive layer has good toughness,the temperature resistant is 300 degree.
2.It's consist of modified heat resistant toughening resin and special curing agent.
3.Aging resistant(can reach more than 8 years),high temperature resistant,medium resistant,good toughness
4.Can cure at room temperature,can also heat for curing.
5.When it is used as repair agent,the highest working temperature is 300 degree,when it is used as structural bonding,
the highest working temperature is 250 degree.

Product usage of our BD300 high temperature abrasion wear resistant epoxy bonding repair ceramic tile adhesive:
With high bonding strength and good toughness, suitable for the bonding of metal,ceramic,cement,glass.
Used in the bonding of wear resistant ceramic chip under high temperature working condition,also suitable for the bonding and
repairing of machine part under high temperature working condition.

How to use of our BD300 anti wear abrasion high temperature resistant epoxy repair compound ceramic adhesives:
1.Surface treatment: Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,
clean it by cleaning agent in the end.

2.Configure adhesive: According to specified percentage(mass ratio:5:1),make A and B two components mix uniformly.

3.Using adhesive:Make the mixed-up adhesive spread coating on the surface of adherend uniformly.

4.Curing: It takes 24 hours at the room temperature（25℃) for curing fully,or cure for 2 hours at the normal temperature then
heat it up to the temperature of 80 degree and keep this temperature for 4 hours for curing fully.

5.Every time the suitable quantity of configuring adhesive is 300g～500g,too much adhesive is not easy to mix uniformly,every time the usable time of configuring adhesive is about 30～40 min,the usable time is long at the low temperature,the usable time is short at the high temperature,
should adjust the configured adhesive quantity according to the actual condition.