How to use of conveyor belt strengthening liquid anti abrasion wear resistant high bonding strength epoxy rubber coating
1.Clean up the pending-smear area and dry it in the air.
2.Polishing the surface layer with electric wire to come out the fresh rubber base material.
3.Wipe off rubber powder from surface with toluene or dry duster cloth.
4.brush coating the prime coat and dry it in the air for 30 min (can not be operation on a rainy day or during the big air humidity).
5.According to the mass ratio A: B = 4:1,preparation of liquid wear abrasion resistant rubber coating,and brush coating on the surface of conveyor belt,
it can be starting up after curing for 6-12 hours.
Note:The usable time of well mixing liquid anti wear abrasion resistant rubber coating is only 10-15 min,should finish brush coating within the
operation time limit.
operation time limit.
