anti abrasion high temperature resistant ceramic adhesive

　　The description of BD281 anti chemical wear abrasion high temperature resistant
ceramic tile bonding repair epoxy adhesive

Performance features of our BD281 high temperature chemical abrasion wear resistant
epoxy compound ceramic adhesives:
1.Two component,white daub shape,it's gray after mixing,with strong initial viscous force.
2.It's consist of modified heat resistant toughening resin and special curing agent.
3.High temperature resistant,medium resistant,good toughness,aging resistant(can reach more than 8 years)
4.Can cure at room temperature,can also heat for curing.
5.The highest temperature resistant is 280 degree,when it is used as structural bonding,
the highest working temperature is 250 degree.

Product usage of our BD281 wear abrasion chemical high temperature resistant
ceramic repair compound epoxy adhesive:
With high bonding strength and good toughness, suitable for the bonding of metal,ceramic,cement,glass.
Used in the bonding of wear resistant ceramic chip under 250 degree working condition,also suitable for the bonding and repairing
of machine part under high temperature working condition.

How to use of our BD281 anti abrasion wear chemical heat resistant
ceramic tile epoxy bonding repair adhesives:
1. Surface treatment:Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend,
finally clean it by cleaning agent.

2. Configure adhesive:According to the specified requirements,make A and B two component mix uniformly.
A:B(the mass ratio)=4:1

3. Using adhesive:Make the configured adhesive be coating on the adherend surface uniformly.
Double spread will get the better bonding effect.

4. Curing:Initial curing for 1~1.5 hours at room temperature,full curing for 24 hours,heat it up to the temperature of
80 degree and keep this temperature for 2 hours,then do the post curing,in this way,can get the higher strength
（≥18MPa）

5. It’s suitable to configure 300g~500g adhesive every time,too much adhesive is not easy to mix uniformly,
every time the usable time of the configuring adhesive is about 30～ 40min,the usable time is long for the low temperature,the usable time is short for the high temperature,
can adjust the configuration adhesive quantity according to the actual condition.